When I began to apply the first film, I do not immediately top left edge of the display came in a bubble, which I thought to be able to even pull out (but it was not so even though there is no speck of dust is). When I went on then, I have arrived to the Home button (if bubble-free except for the upper left corner at the edge). Below, I noticed that the film is cut imprecise at Home Button. Better place I could not film well. So the film has then quite easily, but noticeable down by a huge bubble on the Home button.
Make I could it not more and bubbles bother me even if they do not lie directly on the display. So I decided to remove the film and the next raise, because I thought that possibly just this one film was blended, which can happen of course times.
When I started the test with the second film, of course, I stayed again at the two bubble-prone areas.
For some reason the first bubble appeared again in the top left on the edge of what I found funny. It was moved again close to the Home button, but this time it has just fitted.
The bubble top left edge is not large, but remains in place and can not go to it, will probably come back in the next slide. But when I press the Home button, the film is occasionally pulled up, so that there passes air into it. But this I can be carried out press escape.
On the whole, this is but a sharp and inexpensive film, so as to be frosted films. Two stars deduction due to the offset section of the Home button, which can be fatal and a bladder, which is probably a long lasting partner of each of these films.