When building I had some problems, but for which the manufacturer can little.
You have to adjust the two boom relatively low so it during retraction
not hitting the ceiling. That was for me not possible, which is why I
the boom had to be shortened by 20 cm.
It would be a good idea if the manufacturer for Soche cases some distance
Sleeves would offer for the upper end. Also had my lower supports
in Brown liked better than in Chrome.
Otherwise, the 4 meter awning can without any effort with a finger
wonderful in and out. Although the PE covering something simple build
worked, she makes up only once, a very good impression.
I am fully satisfied and would recommend this product without restrictions.
The delivery took just a few days.
Addendum:
=========
Assembly instructions for one person:
(Because everyone says that you can not install only the thing)
Once the two supports and the middle part are preassembled. The Plans
is secured by a cord so that it can not roll off.
The supports right and left I've put in 45 degree angle in front of the wall,
and blocked at the end with a heavy flowerpot. A prop rejected this
on the left wall where they can not slip sideways.
Then I used the centerpiece at chest height. (Only on the side of the
leaning against the wall plugged dannn poised on the other side and the
local strut inserted.) Then the whole shell with a string was
secured so that the parts can not fall apart again.
Now I have alternately supporting the left and right sides by approximately 30 cm
lifted and pushed towards the wall until the awning halbweegs just at the
Wall stood. (Of course I have the flowerpots always afterwards pushed so
can not slip away) Next, I have easily attracted the supports.
Now just one side solved something and pulled the strut into position.
Then tightened again and did the same with the other side. (In
other routes have to the halt in several stages.)
At the desired position I have everything correctly tightened, the arm
mounted and ready!
I am 58 years old, and the whole thing left me with not even half
Hour lasted. Everything went very easy, with. only the insertion of the central part
some force was required.
So with a little common sense goes well alone easily ...