A few days ago I went hear about this bracket. They Loved by the simple and robust design and is also one of the few holders which you bend right over the terminal and thus can also attach vertical boards.
Yesterday the expected package arrived. After opening a pleasant surprise. The original box was not easy in the package. He was additionally sealed in a bag.
After I have the seal removed, I could open the carton. First I had the right frame in the hand. Now I could see the screws and the clamp. It was still at a guide, this is however not really needed.
The pipes between the joints are made of sturdy aluminum. The joints and the tablet holders are made of hard plastic. At Tablet holder a very good foam rubber is additionally glued.
The clamp for the tabletop, a maximum thickness of about 6 cm and terminals can be thanks to the attached rod slightly tighten.
The individual tubes have (from joint center to joint center) reach a length of about 31cm, thus can be at full stretch a total length of about 95 cm.
The joints can be 180 ° bend (at the joints there are small teeth, so the joints to keep the set angle) and thanks to knurled screw rings can each segment again rotated 360 ° around its own axis.
All locks are a good size and, therefore, good to use.
The tablet holder can accommodate devices between 10.5 cm and 20 cm, while the devices can be up to 2.3 cm thick. Thus, one can also use trays with cover.
The bracket can be rotated thanks lockable ball joint in in every direction.
Because the HR-4 hole Einrastetechnik commonly used by manufacturers, you can replace the Tablet holder also against another holder with HR 4-hole system.
If three segments are too long, we can use this bracket with only two or only one segment.
In summary, I can say I would buy this mount again. Together with the matching app you can use the iPad as a perfect TV in bed - and must be no large monitor hanging on the bedroom wall.
If you have a question, you can ask in the comments like this. I'll try to answer as possible.