The adhesive can be wonderfully mix, the mitgeliefterte glue which I had used for the previous card was very lumpy and needed hours for curing or had time to cure the blocks went off all the time.
The Alumina, however, was for about 4-5 minutes so tightly that the modules ran hardly correct in the position.
Tip: Better first less, so mix for about 2-4 blocks, the syringes can be the amount wonderfully dosing.
Volume is really more than sufficient but can be settle from the outside without the paper does not see well.
Link for guidance: Google -> "Arctic Alumina thermal adhesive" -> "how to apply AATA" but only English
