What struck me the same that is the cap does not terminate even with the rest of the lighter one considers the Zippo of the page or going with your finger on the right side along one notices that the cap well above the rest of the lighter protrudes.
Also lacking is the mounting of the plate with the emblem, which is in fact also not uniform but is down thicker than the rest of the plate.
The falls when one considers the Zippo from the front does not occur because one knows and sees it but from the side I think it's a bit disturbing.
Because both workmanship I would (if it were possible) only half a star as something of each will be deducted as bothersome.
But now I come to the biggest minus point, which may not actually occur in a Zippo in my opinion.
The flame of the Zippo burns unpack immediately after and the proper filling not right, it's just too restless until it burns very high then very small and as long as you can burn the Zippo.
First, I came out of a single case which is why I applied for a replacement, but also in the second Zippo exactly the same problem the flame does not burn quietly processing is deficient.
Only after one has something cut the wick burns the flame as it should, at the factory, but everything should be all right installed so that the customer does not have to help.
If one disregards the small flaws and rework the Zippo really succeeded the emblem is detailed and elegantly staged all corners around and it fits comfortably in your hand.