First, I asked on the homepage of xigmatec (just google it) to the features and found especially the ventilation concept very well done.
The build quality is at a high level, there is a lot of space in the housing and I find the noise reduction really succeeded despite the "airy" housing.
I have the rear 120mm fan rausgenommen and this place mounted a Corsair H50 liquid cooling. In return, the lid mounted two 140 mm fans.
The beliegenden stufgenlosen fan control now of 120 mm front fan and two 140 mm fans run up with only 750 rpm, while the case temperature is only 3-5 degrees above room temperature. Incidentally openings are also already prepared for water cooling to connect externally.
The power supply I have attached below it transports the air from the housing to the outside, as is also the warm air "sucked" out of the graphics card and the Airflow now appears to be genuine perfect. The assembly below brings a lot of advantages, especially you can move its cable so simple and make the whole thing a bit tidier (especially if you do not have cable management at the power supply).
Was what I did not like was that the on-off switch on the front panel with "Reset SW" marked although there "Power SW" should have are (is important when connecting the pins to the mainboard. But briefly removed the top cover without tools, and already it was clear that the power switch comes with the orange line.
The side cover go a little strict, but not rattle it and with some emotion, the Ruck-Zuck up and down. I would not want to see it as a criticism but as an advantage.
The mounting of the motherboard went within minutes across the stage, the fit is just awesome. We should also mention the recess on the motherboard mounting back where you can switch the rear cooler mounts without removing the motherboard. However, this cut-1156 motherboards measured at base downwards a little too tight, which is why the retention should be installed anyway before.
Short for graphics cards fixing: I have a Radeon 5770 installed and can snap absolutely fixed to the brackets of the housing. I do not know what others are there for problems :-))
All in all, I am still very excited and I've already taken the cheaper Asgard for the second computer in the eye. And, then I'd rather back a Midgard :-))
Conclusion: Recommended because very thoughtful and qulitativ quality!