So ordered too much without considering the negative reviews on the off chance.
The machine arrived yesterday, unpacked and first impression - very stable, you would could you ask for this machine a lot more to see this machine in the big office supply stores. What I saw there was going from 50 and was compared to this machine a joke!
Now just taken the first binding experiments - without any problems. When first you take the best first, some lubricating sheets, as this may come to your documents oil stains. These, however, have dissipated after a couple of times punching.
Basically, the whole procedure runs quite simple from:
- Lay sheets flush into the hole punch
- Check again the leaves really behind the attack are (otherwise you have no ordinary eyes and the leaves can be again reprinted straight)
Press lever down -
- Open the lever again and take out documents, while continuing punched until everything is what you want to bind her.
- Insert plastic combs - IMPORTANT: Inserting links from "crest" and let the Ösenöffnungen look up - otherwise you can try your long leaves there insert ...
- Now press the lever to the left, as far as is to the back opens to fit you, and then push the lever back to the right to close the back.
- FINISHED
With just a few dry runs that's no problem.
On weekends, take additional tests. If by my previously positive opinion about this instrument to change something, I will report it here.
Even the shipping and packaging was great - a big thanks to the seller -Verpackungsteam- (do not be surprised, the package comes from Austria)
Even the starter and the stapler can convince.
I hope I could be of help with my review many undecided :)