Our conclusion:
Without knowledge you do quickly with the Set of small quirks a big construction site. You have to do things differently it myself, but then I do not need this set!
!! No recommendation !!
Who makes it still takes time, skill, possibly tin Felgensilber (not included) and definitely polish (not included)
Buy Best Alufüller individually (cheaper), and the rest in the set is always such a thing ...
.....................
Here are a few notes to try for those who are entertaining the idea, dare anyway:
The set:
- Filler is abundant, but it consumes quite a lot, because you have to throw away a lot (see below)
- Paint is fairly thick. Transitions are so difficult to achieve.
- Paint brush is very rough. But if at any Lackstift unfortunately the case.
- Gloves are very thin and wear out quickly: Which steal at Mutti!
- Sandpaper is cheap: Sits down too quickly. Better replacement schedule.
- Wooden spatula. Well: her the filler keeps unfortunately most ...
....................
The Processing:
- The filler keeps better than anywhere on the rim! Matter which one presses him well moistened but not the contact surface of the filler to the rim! Old customers / Debit Card cut - then you have something better.
- You'd have the filler rather thin behalf, otherwise grinds you later NEN Wolf. Unfortunately, hardly possible, because it quickly breaks away from the rim. Through moistening go better, but just at the edge of the rim, it is difficult to "smear" him firmly. Attaching most resembles the process of thick wooden spatula or silicone - is much bitchy !!
- The Verarbeitugszeit is super short: 1-2 minutes !! The 2-component mixture hardens quickly and then adhere even less. So: Cut and prepare small portions. At the cutting edge of the other filler unfortunately this also responds: Cut and discard before it goes to the next portion Thin slide! Therefore, the high consumption of the filler.
- The guide writes that one should remove any excess material after the job immediately .... Hhhm: Can laughter !! If you want to remove the excess material, you usually away with it the stuff that should be in place. Therefore better: As little filler and take abscheifen the supernatant (!).
- The painting with the included brush is such a thing: The paint is simply too thick / dries too quickly and the brush draws grooves in the paint. Our Tip:
1st variant: give Lackstifft girlfriend. On fingernails that stuff lasts forever and looks good. Glitter on it - watch out! Instead, cover rim after filling and completely over it paint (box / gun).
2. variant: fill paint in a small lid and dilute something so that he becomes more fluid and homogeneous drying. Apply a thin layer and allow to dry. Only then might repaint. It is helpful for the application of small quantities of paint is a thin brush from the craft store or even a toothpick. After the paint fine (!) Grind to eliminate last streaks. The fine work is done then the last step a reasonable polishing, the final supernatants removed. Unfortunately this is missing in the set !!
I Wish You Success!!