Film is super, applying only a question of technology!

I've brought the film based on the reviews to the surface and user behavior with respect to S-Pen, although many have the application described as difficult. Since I am basically of the opinion that the application of films is never easy and it is a matter of technique in most cases, I did not let myself be swayed them. After I applied the film, I am convinced that it is true.

In the pack there are two slides, a microfiber cloth, so a spatula and tape, the dust particles can be removed from the film, when it which accumulate when attaching (goes well with Tesa). The films themselves have the top and bottom a protective film which is numbered 1 and 2 and stabilizes the actual film for Aufbringarbeit. As you can read in some reviews of the film, is the guide on the back of pack waste, which is true. The manufacturer apparently assumes that you have films have often attached. Since I knew the principle of the two protective films from other films already, I do not care that was. Besides, the foils are very fit and the right attaching to vote the two holes for the lenses.

The writing performance with the pen has not changed, the Pen slips neatly over it, as if no film would be on it. I also think that you noticed anything else. For me, it feels as though it does not slide.

Now to mount ...

Because of the dust I (not attract lint, so no wool sweater or the like) that after showering in the bathroom and with tight-fitting rubber gloves made what worked well. There was only one small dust conclusion I have left but, as it provides the outer - in my case, white - edge is. Bubbles are not left behind. There were a few, after the film rested completely. The settled out but emphasize effortlessly. I think that it is simply a question of technology and the right Beginnens during application. The procedure I am when applied as follows:

1. foil once launched, to see how accurately it is and how to create your best to get there exactly with the holes for the lenses.
2. Of course, display clean (with lens cloth and then with the microfiber cloth polished)
3. spatula sure to use the microfiber cloth wrapped (the edge is sometimes a bit sharp, because the film but above still has the protective film, can not have too much to happen)
4. With the narrow side left I started, that is a piece of the lower protector (numbered 1) from left to right for about 2 - 3 cm Pull.
5. The exposed film applied on the left, silver edge of the Notes and painted from top to bottom once smooth.
6. Lower protector slowly unrolled little by little to the right and the exposed foil gently with the spatula right pressed leader (not yet completely fixed press !!!) Meanwhile, make sure that the top edge remains clean parallel to the silver edge of the device , A speck of dust, the strayed during this process on the display, I've removed from the film before I got the next placed with the adhesive tape included.
7. After the bottom sheet was completely removed, I have painted in star topology with the wrapped spatula from the center of the display to the outside smooth, thereby resulting individual bubbles have been pushed outwards. In conclusion, I have the edges again repainted and pressed.
8. Upper Protector (numbered 2) withdrawn slowly and finally again with the spatula wrapped - as described above - the actual protector "laid down".
-> Some evaluators have indeed complained that remains an ugly film of the numbered strips. That's not right, because the pull tab sticks yes on the protective film of the actual slide that you ebzieht yes, if you're done!

The application has a total of about 15 minutes. Taken and the result is absolutely fine for me. As I said, a small speck of dust in the white border area not interfere there and can not be seen. That's why I have not fiddled.

I think it is crucial that the film is possible accurately, then you can invest on clean silver border and works well with the rest of the fit to the other edges and with holes. The film itself is namely top from the surface, it does not feel that a film rests. I feel even when using the S-Pen that. Therefore, there is for me quite clearly the buy recommendation.