Finally, a protective sheath that value correctly defined

Since I do not always take my second unit wanted to have a waterproof phone to record and track vital data while the outdoor sports, I was looking for a good cover for the iP 6+.
Requirement was that it is waterproof and shockproof. You should not apply too much and the weight had to be limited. Finally, I will thus make trail runs and no dumbbell exercises)
I discovered the shell of iProtect. Since I already have other products in this consignor (manufacturer?), The decision was relatively easy. Obviously fit everything as I was looking for it.

After the envelope arrived, I have first tested at Trail runs in the Pampas. GPS is not disturbed (no screening) and the BT-belt for Herzfrequentz works without dropouts.
The water test survived the envelope without any problems. Since I do not sooo many times am staying under water, I do not have long-term test of the water resistance performed -D For dives there are other cases which also deeper meters endure!
Then the more demanding test came on a mountain bike. I have a Richter bracket installed the also 6+ incl. Shell absorbs and holds securely. However, I go partly trails with many roots or "Huckelpisten" where strong vibrations at the wheel. And of course shell falls sometime the device incl. On the ground ...
Three drops were intercepted. The iPhone has come through everything easily. The shell itself is also no trace. Thank you!
Incidentally it may be mentioned that the shell is made clean and the device fits to the millimeter. Since nothing wobbles inside the envelope.
Of course (!) You should pay attention when closing out that on the one hand, the seal is clean and you put around the casing presses, thus compressing the two cups firmly. It is also helpful for the water tightness when one examines the rubber sealing rings of the lower terminals shortly. Such things are but clearly the responsibility of the user ...
So here is a strong buy recommendation from a private user.