Fits great, looks good and provides top protection!

The FoliX protector keeps definitely delivers what it promises: it is for a crystal clear (if they are applied with enough Sorgfall sees no difference to the display without membrane) and also protects the display well!

The application of the film nevertheless proved very inconvenient: After you have removed the display of all dust particles and one sets the film on the screen edge, already new particles have settled on the uncovered side of the display. Here, of course, everyone has to decide for themselves how much dust you want to have under the film willingly - I personally have tried to rid everything.
The supplied Mikrofasetuch is not recommended in my opinion, very, because it loses a lot of fluff and the display so even more contaminated.

Good tip to dust is to apply the foil in the bathroom and before to run hot water for a few minutes so that most dust particles are bound in the air!

(But with 2 people significantly (!) Simple) The application of the film per se but went slightly out of hand. With one hand pulling the slide slowly across the screen, with the other hand to help with one of a protected Mikrofasetuch debit card (or similar cards) to in order to avoid air pockets. This protective film no air pockets were really to see, as it is very good adhesion and good to apply with a map with me.

IMPORTANT: Take care that the foil is not affected by the adhesive side, because as fingerprints or small grease stains are trapped under the foil.
Also: The film as quickly as possible, apply at the screen, as otherwise dust gets on the adhesive side and interfere at the end of the film.

TIP: If you still stuck too much dust under the film, TESA-film is a super opportunity to get rid of the dust. On the one hand you can with the Tesa strip the film easily removed (Just from one corner diagonally to the opposite corner and stick a strip Peel off the foil = dissolves!). This saves the hassle of scratching at the corners and spared damage to the foil.
Then raise the film slightly and pull it off with small Tesa strips the dust particles from the adhesive side of the protective film. Do not worry, the adhesive film of the Tesa strip leaves no trace of the protective film.

All in all, a super slide, for you have to bring patience, however, when applied, if not everything works as it should.