If I want to use as a slave flashes and turn on via the camera flash, light up, but so early that I have nothing of its light in my picture.
When I think about Remote Control Metz let light flashes and then let react the wireless flash bulbs on their photocells, light but so I do not by their light nothing in my image had too early again.
A combination of PC sync cable for flash bulbs and Remote Control for my flashes Metz also does not go.
Here, in the Olympus forum I have reported on this problem: [...] and kindly I got hints for a solution:
Both control flashes are the RC flashes, as well as in TTL flash fires before the flashes that start the flash bulbs too early
So the timing flashes of Remote Controls are to blame.
So one has to:
- Make flash the camera to Manual,
- Dispense with the remote control of Metz,
- These fit so that the join and adjust the settings manually as well with the Yognuos receiver.
The Yognuo radio transmitter (not for the flash bulbs but for the actual lightning) is then normal to the hot shoe because the camera flash is not needed anymore. The Flashbulb be turned on by the light of the radio-controlled strumpet.
I have tried not yet there. Whom have I tried the near future I will report here.
By and large, these flash bulbs give good useful light. As skin flashes on PC Sychronkabel do their job well and particularly favorable. They are therefore recommended. In my case should come as auxiliary lighting in use so I write about it here.