After attach to my iPhone 4 but disillusionment. The back is cut too small, although clean glued to the right outer edge along missing on the other side determined 2mm sheet. The same image at the bottom. In addition an Apple logo that is no Apple logo. The lower edge of the apple is cut off, the curvature of the bite clearly not comparable to the original. Camera and flash on the other hand perfectly.
The next step was the side panel, which is also a lack of fit. While at the volume buttons below 2mm distance, the mute switch is missing above 2mm. The headphone jack is covered almost to half. The fit to speakers and DockConnector is ok. The length of the strip is also not sufficient to get from antenna black interruption to the next. It flashes still neat metal through and not symmetrical as I could not cope.
On the front, a similar picture.
On the film, the rating is not, which is great. At the cut, however needs to be worked hard. In use with Car it may still go, because the edges should be covered.