However, since last worked only one program. After that, the controller assumes no new command more. The only solution: Power off -> power on -> Quick select another program (within 5 seconds), this is then realized and executed, then nothing beats again and want to change the program again you have to take the power away. As was well saved on the controller. It's too annoying in the long run. These breaks my Powerline network of 5 MB / s to 2 - 3 MB / s when the strip is on. The power supply would seem to have also installed a filter. Very sad, but the thing goes back via Amazon. Unfortunately, only refund is possible and not a substitute. Maybe I only have a "mon product" caught but when I look at the comments Powerline intolerance and the controller Macke is listed by reading quite häuffig.
I'll have to do my best probably for another product.
Robz