Unfortunately, my first application attempt totally went wrong - by following the instructions.
A tip: If you have pets (with fur) should be Bad thorough vacuuming / cleaning, then run as recommended in the manual hot water (and door), then take off all the clothes (and jepp, in doubt, then you sit in underwear there ;)) who come into contact with the pets (otherwise glue the hair faster at the bottom of the foil as you can see) and then very slowly (in centimeters working), the film applied to the piece of cardboard. Make sure that you pushes resulting bubbles, or simply again take off the foil slightly.
I had seen the first attempt at the end that there was an extra hole for the camera, because it's hard to see through the lattice-top film. On the second try I just put in the original state, the grid as a guide and a portion on the side cut off, so that the camera is not covered by the film and at least the part of the tablet with the film is covered on the one really can draw ( not necessarily on the black margins on the side).
Too bad that the first attempt was in the pants, because the films are quite expensive :( But if they are having time on it I have to say top much, much better than the crystal clear version - both from her characters feel as well as for.! palm. Whereby When Cintiq Companion anyway recommends anzuzuiehen a Smudgeguard (glove), due to the touch surface.
I found that the film Thank God also does not affect the image playback and touch gestures, etc. work just as well as without foil.
Should anyone have any questions, just tell me:)