Bought with "Cables Arduino Breadboard female female" following the advice on Comment t-cine, I could install these 433mhz modules without problem on my Raspberry Pi, taken to control Profile (FCP-310 model) . This works very well and easily with the tool 433Utils (RFSniffer to capture codes codesend for replay). In terms of scope, without welding antenna and power 5 volt Raspberry, the transmitter door a few meters, but the receiver much less, a few dozen centimeters. This is not a problem because the receiver served me the time to record and analyze the control codes from the remote control and the scope of these components can be greatly increased by welding an antenna. The transmitter can also gain range with an external power supply of 12 volts. In short, very satisfied with these products (cables, transmitter, receiver) that are well made and perfectly meet my needs :)