Now go the original inks, one after another over and the reconstruction of cartridges used. First, magenta and cyan, it worked perfectly. But then came the large black cartridge and thus the trouble. Cartridge inserted - it lights up no red indicator light. The following pressure test fails, the printer will display an error message, it does not accept the ink cartridge, I should use a matching. Since I bought 4 sets yes, I therefore take the next cartridge. Closing down - and the mess is pefekt: tabletop and my pants are dirty with the black ink. After I had tamed the leaking ink with a rag, and this cartridge was set in the printer, but again not accepted by the same score, the cartridge from the printer. So get bought in the store, an original cartridge, used printer runs.
I'll wait for now even if show any adverse change in the printed image. If not, then I can hopefully use the remaining "small" cartridge. Of the remaining two large black cartridge I leave anyway fingers. Should any inconsistency arise now, I throw the replica-things away and bring me back all the originals. Although the are outrageously expensive, but that I had with my old printer never even the slightest difficulty.
