[Optimized for SSD, aluminum housing] Inateck USB 3.0 2.5 inch External Hard Drive Enclosure for SATA SSD HDD 7mm 9.5mm USB 3.0 cable | Full aluminum housing | Installation by screws | support PC / Notebook / Mac (SATA3 support UASP) (Accessories) 2
[Optimized for SSD, aluminum housing] Inateck USB 3.0 2.5 inch External Hard Drive Enclosure for SATA SSD HDD 7mm 9.5mm USB 3.0 cable | Full aluminum housing | Installation by screws | support PC / Notebook / Mac (SATA3 support UASP) (Accessories)
Hard disk can be good block in the housing and fasten with screws, but the case itself is processed very unclean. The gaps are not correct and both current as well as USB cable slack. To make matters worse, the hard drive has been set up then also (HGST Travelstar 7K1000 1TB internal hard drive (7200rpm, SATA 6Gb / s, 32MB Cache 6Gb, 6,35cm (2.5 "))) adopted after two hours and was no longer repair. Whether it was the chassis or the hard drive has had a stroke, I can not judge. I have the body returned and ordered me another (USB 3.0 & eSATA External anchor HDD enclosure Hard Drive Enclosure for 9,5mm & 12,5mm 2.5 inch SATA I, SATA II, SATA III HDD and SSD, Toolless HDD installation), the risk of further broken hard drive was me then too large