Lace monitor

Class Monitor, previously had a U2312HM. This was quite good, but I wanted to change due to the "Flicker Free" technique ([...]). Since I am somewhat lichtempflindlich my monitors are always set to 20-30% brightness (100-140 cd / m²). Here one really notices the sub-sliding because the eyes no longer tired when U2415. The image is razor sharp and the colors are noticeably better than the U2312HM. The black is really scharz and even with single-sided light from the window of Montior dereflected very good and there are so minimal Farbnouncen visible. The "Touch Buttons": needs some getting used, but I get along well with it now. I turn the monitor off when leaving the computer, and had until now no problems. The monitor is the way much thinner, lighter and handier. It can be turned down almost all the way at table height.

Tips for use (which I found out after some time schmezlich):
1. HDMI avail: all motherboards support in the BIOS / EFI no DisplayPort drivers, ie if you connect the monitor via DisplayPort one sees only an image when Windows and the driver is loaded. You have to use HDMI To change something in the bios. In addition, the Windows DisplayPort driver sucks, resolutions in multimonitor operation are "forgotten" and it takes a few seconds to display an image after turning on. No comparison to HDMI, DisplayPort is not yet practicable. I have an adapter from HDMI to DVI (because I need the HDMI graphics card for the sound), which works wonderfully.
2. If necessarily be DisplayPort: change the menu on DisplayPort v1.2, otherwise the monitor shows streaks on (as I said, the driver sucks)
3. Brightness at 36%: entsprich the recommended 140 cd / m²
4. Otherwise, default settings: must be changed depending less in USD Monitor, the better. By nature, the monitors are very well optimized, here is a calibration report with.

Vollsändiger "proper" test on TFTCentral:

[...]