LED strip hui, remote Pooh

Despite some negative review I have dared to order the LED ribbon. Before it, I've adhesive once tested it. And lo and behold: It works. I could change color, dim and test the programs.
Full of anticipation, I then now adjusted the tape and shared it. With the two connectors on the controller that's not a problem. By extension, I can cut as 3 strips me. Always tested again if the tape is still on when I glued and assembled a piece. Everything is wonderful.

When I finished, I realized that I suddenly had 3 different colors (each of the sections had to be specially "Yellow". So all interfaces and cable controls. No change. If I used only one port on the controller, then was suddenly strip. I have red again both connections plugged, then everything was yellow.

On the remote control the whole thing has not stopped responding. I now have a color in 3 gradations. If I have time, "happiness", then lights up everything in white. Unfortunately that is not the desired effect in my bar.

So I once swapped the battery. Without Success. The other machine I could even operate with the battery of remote control LED.

The light itself is great and the tape also. I think the dog is buried in the controller (and / or the remote control). The remote itself I have not even used 5 minutes. Too Bad. In principle, a good product but unfortunately I got this Monday with the remote controller. Therefore, only 1 star. Because it lights up yes. ;-)