The plate holder was there within two days and already convinced unpacking through processing, dimensional accuracy and surface finish. The coating also looks like she would keep forever. When growing then the next reason to rejoice: fits without any ifs and buts to the original breakpoints. Only the material thickness is less than that of the original part made of plastic and therefore one needs four washers, so that the wearer does not rattle on the holding jacks on rear frame. But who does not hinbekommt who lets eh converted into a workshop. :-) 'M Curious whether this holder the vibrations of V2 better withstand when his aluminum brothers ... have already had two by wily holder and therefore specifically looking for one made of steel. In short, very fine and visually beautiful part.