My last is broken, now needed a better ....

... I have times been given an aluminum vise. As I turn often 8mm stainless steel when cold made of aluminum vise tired and broke.
Now I've been looking for a solid but the vice is well affordable.

He looks solid from but this is deceptive when too much force I think breaks the thread guide in two, or the thread breaks out. But he did turn the 8x30mm steel good survived. The ability to turn him to the turn because he was irritated not so tightly that he gets bend the side without rotating with power. But with few Crad rotation he remains standing anyway. The rest use the opportunity was to turn him even pleasant. I must say that it suits me very personally. He holds the out turn is rotatable so it makes my job well and it fits halt. The jaws appear to be well-tempered as they aufzeigten after bending not wear it but had the good workpiece to be bent 0.8mm footprints.

Addendum: I have seen the the thread guide was angeschaubt retrospectively, ie A) replaced B) it is also made of hardened steel.

+ Kept my endurance test from!
+ Rotating a real relief!
+ Good hardened jaws!
+ Price / performance TOP !!

- No real drawbacks

That was for me the most important points! I would buy him the next time again.