The adapter comes with a SATA cable 20 cm long and a power cable to the card.
The included SATA cable is too short in the majority of cases.
After unpacking start guessing, of how it works ...
First on the map a jumper must be positioned to select the direction IDE - SATA (position 1-2) or sense SATA - IDE (position 2-3). The card has two SATA connectors. For IDE sense - SATA, use the "Motherboard SATA" connector. In the sense SATA - IDE using the other connector.
For power, it is necessary to use the additional cable to directly power the card, from a Molex plug. Also, do not forget to normally charge the device.
Connect the card to the device and the motherboard. The card is connected to the device to sense the IDE - SATA, and the motherboard to the direction SATA - IDE
The hard part is done, the connection is immediately recognized power.
Technically 5étoiles merit, but the lack of notice and the SATA cable too short, are losing 1 or 2 stars.