I can convert this lead already once. However, after about 2 months occurs the same defect: the cable is broken at the Micro USB connector and has a permanent intermittent contact. This means that starts the charging process are constantly new. Not good.
The cable is a charger (redirect = true & ref_ = oh_aui_detailpage_o02_s01) combine touch tablet with Samsung. I had the intention of being able to use it during charging. That worked pretty well at first, but after about 2 months and occasional use is the cable. Presumably it is the solder wire / Micro USB connector. I have the cable not (yet) open in order to prove it can, because the charging process works in "an impassive state" yet. I use it so occasionally.
The Micro USB connector itself is very robust, meaning that it holds the heavy cables reliably in the socket, even when moving. And so the balancing act is evident that the manufacturer has to accomplish. On the one hand, the cable must have a certain cross-section to allow a high charging current for a length of 2m. On the other hand it makes it difficult and the small USB plug, it must be electrically and mechanically "bear" (This is of course also true for the USB connector, in my case the tablet, here's nothing to complain about).
Conclusion: for the purpose of using the tablet while charging, this cable is not suitable. A renewed exchange will save me because of errors in the same way and at the same place occurred during replacement.
The original cable from Samsung