Only the holder is bad

I was pleasantly surprised by the (not expected because in the article description on read) Car Power Adapter for headset: A 1-amp plug for 12V connector with a standard USB-A port. At this also pretty much any other USB device can then connect, so that the mobile phone power supply is actually superfluous. The headset itself looks quite cheap, but not too surprised at the pricing of this article.
I was disappointed, however, by the smartphone holder. The locking wheel for the sucker looks cheap and has a lot of game. The smartphone is clamped in the holder, which first requires a strong pulling at my Cynus T2. Then you have to have to be careful that you do not become trapped, the volume rocker with. Handed this procedure is difficult to create. The jig then seems to be reaching the end of their elasticity. Whether my smartphone is the future still fits with a undelivered Flip Case in the holder at least questionable (but perhaps not intentionally).
The suction cup holds no great stress was.
The attached charging cable pulls through his spiral cable rather on smartphone (although I think that the distance from the windshield to the 12V socket in my car is not higher than average). It has been a bit worried about the USB jack of your smartphone and initially the combination worked spiral cable + weak suction cup as projectile towards the vehicle center. Having stretched the spiral cable, the effect was significantly mitigated.
Although I run the mount in landscape mode and the holder have positioned so that they can rest a little on the dashboard itself, dissolves occasionally (sometimes in the state in direct sunlight). The holder is not to be used as. However, since the smartphone chuck fits on my sucker defective navigation system, this 'loss' for me is bearable.