Here, the cable has be very easy to install and the curvature at the corners were minimal so that the stucco could still be clean it launched.
The cable is also not too thick so that it can hardly be seen in the vertical wall corners with a little additional acrylic and new paint.
My wife is thrilled - that says it all! (The cable clutter previously was a disgrace, just because I wanted to have necessarily a 5.1 system ^^)
So I did it:
An approximately 0.5 cm thick acrylic bead in the corners along pre-squirts, cable on a stalk between two chairs prepared (so that there are no twists - set to roll), pressed cable in the corner on the acrylic, rubbed ausquirlungen and so little by little further verleget. On the ceiling, I have the cable laid up in the meantime, so that it does not again subtract by the weight itself (cat tree, curtain rod, etc.). If it is once angepappt with the acrylic remains even glue and anything can and consolidate peace in dry itself. After a while again injected into the vertical corners with an acrylic bead over it and be paving the lateral grooves. When everything is dry, if necessary, again sweep to the wall color - and you're done.