Hi Guys, Here are my experiences: OK OK, it is quite simple. In the manual it is somewhere very small, the IP address: 192.168.2.2. This you have to enter in the input line of a browser and you're done (without [...] Should no contact with the input mask of the print server, so you have to your own IP address check as follows: -Start Settings Network Connections -LAN Connection -Features -Internetprotokoll (TCP / IP) - * Use the following IP address. -Here Enter an address with 192.168.2.xxx (a. After two or Tab). Subnet mask wears as follows: 255.255.255.0. Confirm and wait briefly. Now, you should come to the surface of the setup screen of the print server. Do you have no success, so install the bundled software. This is the print server by its MAC address. (Access to the mask: admin, 1234) The settings in the menu vary depending on how your your network organized. Have you, for example, a router with a DHCP server (If AVM with the IP: 192.168.178.xxx). So the IP address of the print server changes accordingly. But you should be careful to select the last number so that this is outside of the DHCP server. So about: the DHCP server of 192.168.178.10-100, Render an address with 0-9 or 101-354 as the last number. This ensures that the DHCP server can not change the IP address of the print server and you do not need tracking constantly manually connect the printer. Now for the downside in the instructions. Setting up the printer: -Start Settings Printers and Faxes -Rechtsklick Into the open field Add printers -further - * Create a new connection (contrary to instructions) Store: Standard TCP / IP Port -further -further -Here those of you fixed IP address of the print server so enter: 192.168.xxx.xxx (to not forget.) Port Name is sausage, always leave everything as Windows suggests, only change if need be. - * Standard Generic Network Card. Again, if not better known the proposals Windows follow. -further Make -Fertig -The Printer is usually detected. If not, can browse through the CD disk of your printer. When newly maintained driver -Now The name assigned such as the printer you want to appear on Windows. Again, the rule to follow Windows proposal. -further - Let * yes Print Test Page -and done. This procedure you must perform on any computer that is connected to the print server. One oddity I have: I have the password changed twice and no I do not have incorrectly entered, but I did not get to the mask. Wrong Password? hardly likely. I suspect that part has also changed the login name and I habs not noticed. Well it is also not really a reason to change the password. Another tip: you write the IP address on a piece of paper and stuck him on the device to the address to access not having to remember. Oh yes, the changes in the registry prevents usually from the firewall. Here, then, turn off or allow manually. And now a lot of success. PS: The Status Monitor will not work with a print server. So you can not see the level of the cartridge or the toner. But if all print servers of this type that.
