Positives:
-Right massive construction of table and frame
-Motor Has power cuts with a NE sheet thicker profiles like butter
-Schraubzwinge (Left in picture) is a useful addition, I did not expect
-Feinjustierung Via screws with lock nuts -> Simpel
Macken / Minor niggles:
-Staub- / Dust bag is completely pointless! It ends up only a tiny fraction of the chips in the bag. If necessary, experiment with a suction and test.
Bearings for tilting the machine in the angle 0 ° -45 ° has gerinfügiges game. Can be adjusted about the great mother, but if you turn too hard, which is lowering the head stiff. So you have to live with a very narrow margin. But is not a problem if you're not Grobmotoriker and head herumreisst while moving it downward.
-Motor Comes when switching immediately to full throttle. No soft start. The would have been nice.
-Volume Seeeeehr high! Hearing protection urgently (!!!!) advised. But that should be familiar to anyone in connection with goggles anyway.
-To Fine adjustment should be two (not too thin, the stop at the table below has a gap) Squares with not too much leg length (max. 10-15cm!) On hand (90 ° and 45 °), since these are not supplied , In a pinch, it also does a set square, if you can do without setting the 45 ° miter first and going wisely.