The TechniRouter was installed in front of an existing multi-switch. The router has 2 outputs. Through the router coming from the LNB satellite signal for each output to 4 different channels is implemented (channel 1 = 1284MHz, Channel 2 = 1400MHz, 1516MHz Channel 3 =, channel 4 = 1632MHz) By frequency moderate reaction, the satellite signal can be transmitted via a cable 4 times. I have currently connected to each output in each case a terminal box with a Satreceiver with twin tuner. So use two of the available four channels. The two currently unused channels are to be used later for a TV with twin tuner at the same location. It is nice that I can now use the full scope of the twin tuner for example, viewing a channel and record another channel at the same time. Restrictions on the transmitter (same polarization, the same frequency band) is no longer applicable. It is important that the connected satellite receivers or TV sets support as antenna setting "Unicable" or "SatCR LNB EN 50494". Only then will you be able to receive the signals transmitted over the TechniRouter.