A strong buy recommendation!
The installation I have done alone, but is likely to be much easier because the mount installed and yet is relatively difficult to second. The included mini-bubble level is nice but I have not even unpacked, trust because my dear Great.
Who has bad masonry brick or older, better not use the supplied dowels. These are just simple expansion shields and not very long. I have six 8-screw replaced by ten pieces 6x100 with long fixings biceps 8/90 (spread over entire length). I have only one 37 incher popped in 42+ would I'd rather take back 8er screws said biceps-anchors. Costs for these dowels + screws under 5 at the hardware store (Horn ...)
Determined position of the holes on the wall, drilled holes and the bracket is screwed to the wall. Now the support rails screwed to the TV and the TV hung in the bracket. Almost straight, crooked in the millimeter range. Never mind, front panel can be adjusted.
The front plate is in the delivery state only semisolid "so that they just still can do. Holding plate slightly up pressed on one side and absolutely straight. The screws of the plate (3 piece, 10 hex) but tighten now, should not longer be adjusted. The tilt the front panel I've just been visually and determined before mounting (2 levers).
The 15kg of my 37Zöllers not interested in this bracket. No matter where I swing the holder, the TV is always straight. That's how it should be. The bracket is a little stiff, according to some silicone spray in all joints it swings significantly lighter.
For size of bracket:
My 37 inch covers the holding plate and the rails just as from the sides and I have above 4cm on each side and below the 6cm of TV is larger than the holder! In my Philips televisions the retaining plate obscured by their size following connections: satellite, headphones, Scart and the Component Video Connection. When satellite connection, however, would still have an angle adapter space, as the headphones. The side entrances are barely accessible (see customer images). A cutting off the plate I would not recommend otherwise the vertical rails of the plate can slide, the retaining screws should go up, will you?
(Cut has been proposed in the black holder times)
Tip for those who like me have to adjust the mount daily, for whatever reason: I have a furniture handle rear mounted on the front panel. This allows the holder much better grip and adjust (see customer images). One should not draw on TV and press yes.
Despite the covered connections (which I do not use anyway) full 5 points, more is not so.
Edit 16:12:12:
After more than a year use the following addendum:
The holder grips and fit as the day !! I've never had to adjust!
Continues to be a top part and thoroughly recommended!