The far as I know from polycarbonate manufactured housing are very rigid and of good quality! When tightening the fan screws is please! ALWAYS! necessary to ensure that these are maximum tightened to the point, until you realize the resistance from the tightened thread (in no case further!), since overtighten the screws, the housing of the fan can be warped. This may cause a rattling and a subsequent bearing damage within a short time, because the fan is no longer running smoothly. This applies not only for these fans, but is generally observed. Be it Revoltec, Cooler Master, Enermax, be quiet or as here NZXT.
The only drawback that you can chalk up these fans is that they are quite expensive. Here some buyers are put off if necessary and then engage but to another brand.
The packaging content consists of:
- A 4-Pin Molex bridge with a 3-Pin fan adapter
- 4 black mounting screws
- 120mm NZXT White LED fan
But from me a clear recommendation!
I hope I could give a little bit of fan, any questions, please comment!