Tutorial:
So who gets his hard drive does not appear in My Computer on Windows is the following masses before:
1. Press Start.
2. Open Control Panel (menu right).
3. Management
4. Computer Management
5. Storage> Disk Management
6. Fals a hard drive without volume Designation find her here, click on it and looking at the bottom of the window if the clicked hard disk storage capacity of your WD hard drive corresponds (2794.39 GB) !! **
7. Does this need to, you only make right-click on the selected hard disk and go to drive letter Paths. There you press the Add button and select any drive letter and stores with OK.
8. Now, the hard disk should actually appear in My Computer.
**. 9 Aufscheind Fals Do not see the disk in Disk Management you have to proceed as follows.
10. Start> Run> CMD
11. In the CMD "Diskpart" into writing (without "") and press ENTER.
12. Now "List Disk" into writing (without "") and press ENTER.
13. Now would appear a disk with a size of about 2794 GB. Fals this true mark you the disk number (eg. 0 or 1 or 2)
14. In the CMD select disk x (where x stands for your number) and enter bestaätigen (then looks approximately like "select disk 0").
15. The message "Disk X is the selected disk now." should appear.
16. Now enter the command "create partition primary" (again, without "") is the command should ensure that the disk is formatted and Windows recognizes it.
17. A message should appear that the process has worked.
18. Now you can go ahead and search the volume without designation and with the 2.7 TB in step 6.
I hope the guide will help some to run faster to get the hard drive when I (a whopping 6 hours)
Your comments, questions and suggestions I would be delighted.
mfG Gasser Kurt
