Already the first impression was actually quite convincing. The opening is a little stiff, here would certainly be a push-button or something useful. Nevertheless, this is absolutely no reason for a devaluation, because everything is still in reasonable range. Anyway, in this charger contacts in the closed state are protected.
The package includes 4 Wechelplatten (all for Canon!), One is pre-assembled, two are clearly visible stowed in a box, one is hiding something tucked under the "Everything". I always examine packaging carefully and always look to me, as the elements are in their original packaging, so that I can pack everything properly again, I have found the hiding place to this plate. A glance at the contacts is sufficient to me to reveal the required disk. Somewhat later I discovered the sticker, which for each battery type indicates precisely the plate.
The pre-assembled plate can be solved by pressing a mechanical lock down easily. Perhaps this is the trickiest action, people with stubby sausage fingers will probably want to solve the delicate mechanism here rather inelegant. Nevertheless, here is no need for a devaluation. The benütigte plate can then be just as easy to push up to the stop. Nothing is hackelig here, as described in other posts wide last.
Inserted a first battery, the indicator lights up and shows the remaining capacity in%. However, the statement deviates strongly from the camera's internal display from (30 to 60% in the camera). But who tells me now that the false statement is? Once solved the battery and re-inserted, the display will change only marginally. A 100% battery shows however both the camera and the charger 100%. I assume that the charge remaining indicator Although relies on the same values, but they are interpreted differently. For the first time no reason for devaluation.
Now connect the power supply, it is indeed an external power adapter (I personally like not so much), but it also leaves here a quality impression. After anschlissen the power supply, the charger begins naturally to load. The original charger here an LED flashes in 25% increments. This charger has a% display. This is probably numerically accurate, but I doubt the value of an ad in the last% point exactly. I would have rather used a time stamp, which indicates the remaining charging time. The display is very angle dependent, but otherwise fine. Just specify: the flashing I see from the corner of my eye un even in darkness and in the far distance. The designer of Canon have accomplished meaningful here. No need to write-down, the display on the charger Hahnel fully served its purpose.
Currently just loaded two batteries, at a later Zeitunkt I'll put my experience here at the moment.
As a preliminary conclusion:
- Nice design, the Canon charger are however verabeited something valent.
- In a two: to load simultaneously two batteries is certainly beneficial!
- Removable disks: You name the camera, we interface the accu. The loader is very viellseitig usable, which of course increases the benefits. The plates are, however, to use as a tandem, that is, both shafts must charge the same battery type. For me, this is no problem, but depending on the equipment, this could of course be a nuisance.
- Processing: good.
- Description: Moderate, vol all are at 3 different places to find information. Those looking for the place.
- Benefits: Very high because simultaneous charging 2er batteries, also from the car. Very useful on the go, if you forgot again to charge the batteries, but the shooting date is fast approaching, and they are gone.
Remain now only the usual (and unverifiable) doubts as to the charging strategy. I hope that this is adjusted according to the type of battery and this therefore just as long remain fresh as the original charger charged batteries.
A good product, my first impressions after this fully recommended.