simply, quickly and easily

The delivery came as Amazon predicted, and the product was free of errors.
After installing the hard drive, the device was immediately recognized by Windows (Windows 7, 64bit, USB2.0 + 3.0).
The aluminum exterior is beautifully robust.
Material, equipment and cable / compounds are of very good quality.
The internal technology is minimalist practical and not embellished useless.
No long cable, just plug slots for power supply and data transmission.
The small foam mat at the end and the two guide rails on the left and right inside (slot for supplied plastic platelets) provide a very good stability of the hard disk! Absolutely no wobbling or slipping!
Sorry, no installation instructions existed.

As has been mentioned several times, its own Phillips screwdriver must be used !!
I was also a little hard done when tightening the screws, as they were a bit small and often eindrehten side.

Installation:
Unscrew 2 screws at both ends. 3.5-inch hard drive to the Attach one end. Both slide together back into the housing and not push the short cable! This end with 2 screws tighten.
Before zuschraubt the back, you should definitely push the supplied plastic plates in the left and right side of the case where the guide rails / slots are available! This gives the hard disk sideways a very good grip.
After screwing the cable plug, and the device should be easily recognized by Windows.

Conclusion:
4.5 of 5
(Deduction for Schauben and screwdriver and a lack of installation instructions)
PS: If errors occur, I'll still resent.