Decisive here was the ,, 80 certification '' and the modular cable system, which should especially facilitate later access by the lower number of restraining cables; This has been confirmed.
Immediately after the removal of my old LC-power power supply could be accomplished because of the narrow construction of my AzzA Toledo 301 with a lot of hustle, I built the WPM 700 and closed at the appropriate cables. Now that all the cables are wrapped, the aesthetic value of the system is also increased, as the cable bustle is mostly gone.
The power supply is fully functional and (yet ...) very quiet. A 140mm dust filter that should improvise the power supply in its longevity and was therefore ordered the same, was due to the fact that the same light also highlights the power supply and makes it impossible for the insertion of the screws, not be used, but this is more of an incorrect calculation on my part ,
The power supply unit now operates the following components: Asus M5A78L LX, AMD FX 4100, Gigabyte HD 7770, and three case fans and a 500GB Seagate Barracuda ,, '' hard drive .. The only drawback is the length of the cable S-ATA cable which seemed a bit too short to achieve my drive. This could be connected only to the second enclosed Cable absence of appropriate S-ATA Verlängerung-.
All in all I am very satisfied. Whether this can still say after the installation of additional components, I will grudge course.