negative:
- The entire vise is smeared with grease for rust protection of steel surfaces open ... just extremely much. You can put it in the beginning not unpack easily without that he might slip out a hand and after that everything is full fat. This could have been achieved much more economical
- The screws for the determination of the turntable are too long. You have to place under both screws so they do not get stuck on the ground, a washer (M12). I got me so first the countertop beautifully scratched after the first tightening
positive:
- The accuracy of the guidance is relatively good. The jaws are together very precisely and even with heavily one-sided strain on the deviation is 150mm jaw width less than 1mm.
whether the stability is sufficient in the long run, I do not want to vote. I still have not had work would generate a vice extreme torsional forces. For straightening of 2mm stainless steel angles in which a small vise is broken, but they range in any case.