Strong stirrer with large housing error

Did I just give yourself a new agitator, although my current> Braun Multimix 280 Watts, Type 4643 Made in Spain
The MQ95530 Siemens (BGL. With the Bosch MFQ3530) I did not vote for the 450 watts, but simply because it is currently the top model from Siemens.
In Rührgerätetests yes finally came out that the wattage is not everything and some 300 Watt devices more powerful and better than 400 watts devices were.

To wattage: at the highest level 5 the outlet ammeter Conrad Energy Check 3000 showed about 25 watts at idle and under full load (extremely tough, rubbery bread dough) just between 80 and 90 watts of power to..
The 450 watt indication on the packing u. Devices labeled thus represents a fictional fantasy figure and has nothing to do with the true power yet with the power output slightly.

However, the kneading result convinced by whatever marketing wattages this device is provided. Even after 8 minutes Extreme-kneading the stirrer is not hot, but only minimally lukewarm. With the extremely tough dough, which provides a maximum load and greatest challenge to the device, in my view, the MQ95530 had no problems. The electronics tried to keep the speed as constant as possible, which will also work quite well. The power increases to 110 watts, and the speed is slow only to nuances.

The 5-stage switch works well and has good grid resistors. But what something cheap acts of Made In Slovenia device, the internal potentiometer switch itself. This is namely a simple potentiometer, which is scanned in 5 stages. So you can for example. The speed at each stage still vary minimally, because the switch between the stages has some play.
Could be regarded as a defect (flaw) in a top device, did not bother me personally, however, because these simple and inexpensive switch solution works well, at least in practice.

The blender for available I did not buy, because the device is too heavy and unwieldy as a blender. In addition, the blender would operate only in the high pulse level (= maximum level 5) as being blocked in the open door of the mixer tap changer in the right direction (1-5).

And now for me to single, yet extremely serious mega-bug of the device: the Shark tailfin !!!
Which impractical Amateur intern because this case has created? Certainly someone who or which has never used a mixer in life, because the lower tail fin hard plastic one remains permanently hanging on the edge of the bowl. This device One must therefore always easy keeping tilted forward. To this end, I have no words!

Pro:
- Powerful motor
- Volume acceptable (not silent, but subjectively ok.)

Cons:
- Only a blender speed level
- Catastrophic, impractical lower tailfin
- Misleading wattage