I am very impressed by this film. Already for many years I use screen protectors for various electronic devices. However, still was not there, who went to stick as easy and clean. In the pack two films are included. So you have a replacement for later or equal, if something goes wrong during installation. Also the delivery this is a small microfiber cloth to clean the screen and a small cardboard for bubble-free smoothing of the film. The film itself has two protective films and these protectors two handles. I first cleaned the screen thoroughly, then peeled the protective film from the protective film :-), launched the film on the display carefully and painted something smooth with the cardboard. Bubbles there was virtually no, just a little on the edge, who were out to push the board immediately. Finally, subtracting the second protective sheet - done. It does not appear that a film is on the screen. This is absolutely properly matching and in no way affect the display of the screen. So fast and bubble-free I have glued no film. I am very satisfied.
Note: The only drawback, the instructions on the back of the package is only available in English. Now, if someone can not speak English, this could be problematic. Therefore, even here the corresponding translation:
1. Clean. The screen with the microfiber cloth from dust and other contaminants (fingerprints) 2. Pull the label number 1, the protective film off (stands with me Step1 and Remove me on it and the label is green.) 3. Place the foil gently on the screen (on the one hand, and then start the other side.) 4. Take the Pappspachtel and press any air bubbles out laterally (debit card is also good) * this point I have also inserted 5. Drag the second protective film on the label from (With me Step2 and Remove me written on it and the label is dark green) 6. Finish