Use this power supply is not as radio power supply, but for the batteries required in model (NiCd, NiMH, Lipo, Lifepo etc ..) to load by Chargers. For this power supply is suitable sehrgut and also favorable in relation gesehen.Denn 50A and more is already a lot. Many also take yes SPS9400 with digital display and 40A and teurer.Es is quiet and not too heavy, also from my point of view more compact than you might suspect only. Cheap power supplies would disrupt my radio when they get too close (50cm) to the device, this one only a little, but to turn the Noise Offset controller (Whatever makes) is the way. What you can not see, is that there is no banana / jack hat.Man "must" a Klauke or whatever use, for its distribution or Anschluss.Ich have me for each 2 4mm gold connectors on a Ringkabelschuh angelötet.Das works sehrgut , In addition, this power supply has also still the Autosteckdose.Da is now a USB drinn loader, very convenient for Smartphone / Ipad or whatever. The additional terminals forwards are determined again be used. In addition, the switch will praktisch.Da back konstannt 13.8V geliefert.Die Set Up front is thus put out of operation. Those who want to necessarily digital displays found in youtube a very nice renovation Video (English) .The works just fine for a couple of euros if you need it. Because of the guarantee I waive any conversions, but I could imagine, einzubauen.Das After this, additional rear sockets is readily möglich.Platz is enough available. Finally, a tip I read in a forum, which is also understandable. Over time, accumulates in the device can an.Dieser dust especially in the lower part of the board at some point to problems führen.Deshalb should the power supply now and then the dust befreien.Das one makes the PC, Playstation, etc. yes too. Not only because of the heat, but also "shorts" can entstehen.Auch busted capacitors it is haben.OK given whether that relates to the dust ..... able to repair low. Am satisfied with the power supply, hope it lasts forever.