1. The bottom part (that is, the ground) is connected to said Holstab in the middle. Upon this comes then later the drawer.
2. The rear wall is the smooth part without subdivision. Which is screwed to the rear bottom.
3. By this, the side parts are then fastened to the left and right, and in a way that the plastic "feet" are below. The base plate should be between the marked lines.
3. Then the layers are inserted and fastened the little hinges on the conductors and the side panels of the cottage with the little gold screws and the whole then installed in the cage. My hamster however wurschtelt prefer without the ladders on the other planes ... well, to each his own ;-)
4. Then the drawer is reingeschoben ... that's really really hard! I do not know if that ever again ever find out-and if so, probably only by brute force :-) It might be necessary (for me it was so), in the sides of the bottom plate pure turn additional screws as the pure constraints of the drawer For me, the one side wall is somewhat broken down. But be careful not accidentally the drawer with screw ;-)
5. Then, the plexiglass is installed front and bolted to the sides.
6. At the end of the cover with the two big hinges screw and the cage is!
The parts fit all not really 100% sure, but with a bissl violence is the :-)
How and where, however, the two wood parts fixed for open, I have not yet found-maybe I can since someone help ??? That would be fine.
So, and now a lot of fun with the construction :-)