Tight-fitting mount for smartphones to 9.5 cm width

The smartphone holder has a 11,5 cm long arm on which an article is, in that you can plug the phone. This article is connected to a flexible rotating ball head to the stand so that you can align your smartphone in any direction.

By a push button on the back of the tower, the brackets are resolved. Both holding arms, as well as the two feet down and the back covered with a thicker rubber pad. This smartphone is protected from damage and scratches.

The installation is quite simple. Is brought to the suction cup to the disc, it is fixed by the folding down of a lever on the foot. Then you put the smartphone in the holder provided and presses the two lateral arms together so far, until the smartphone is secure and no longer can fall out.

We tested the mount with both an LG L80, as well as with a Samsung Galaxy S3. Both units fit in properly and tight and secure by pressing shut the arms. The latter could even remain in its protective rubber cover.

Then you can align the holder so that you can look good on the device. The bracket holds equipment up to 9.5 cm wide.

To remove dissolving the lever at the base and pulls on the nipple silicone to release the holder from the disc. This is very difficult. The support currently sits very firmly on the wheel and I had to try several times before I could remove it again. But had at the same time the advantage I had to make me not worry that she suddenly falls down while driving.

Conclusion:
A very stable and mainly stuck holder for smart phones in cars.