Too bad ... 58

Had specially chose a somewhat expensive holder, because I promised them that it is solid, as a holder for 10, - to 12, -. One would be expensive phone yes know in a secure mount. Although touted as a car mount, this thought from the outset primarily as a holder for the kitchen (radio, TV, watch movies while you are staying in the kitchen) was. The possibility was the phone to fix mitttels this fixture in the vehicle actually only secondary, planned for longer trips. The holder then corresponded initially well below expectations. The suction base held very stable on the wall tiles and the ball joint allows flexible adjustment in the respective desired tilt / angle. The locking of the ball joint head by rotation lock held all extremely stable ... until then so there was nothing to complain about and the expectations were fully met.

But then the rude awakening ... after the bracket is now more than 4 months old and was fixed at this time a maximum of 3 to 4 times using the small lever on the suction cup is now completely unexpectedly and without unnecessary force here would have been spent exactly this lever chipped. One can not say that it was due to overuse of the lever, because you might have permanently elsewhere reattached the bracket so really.

Due to the broken lever, can now flow through the suction base course no longer sufficient vacuum be established and the holder can no longer serve its purpose and be thrown really only in the bin. Obviously, these are to a design flaw, because precisely there where probably act with the greatest forces on the bracket, inferior or insufficient suitable material was used. The rest of the holder is actually made very good and stable .... but the lever on the suction cup also contains an unnecessary 'breaking point' is.

Hence my conclusion: Too bad ... In itself it would be a great support ... if it were not for the material / construction errors of the lever.