ps
I apologize, because I do not have HD-enabled digital camera, the poor video quality. For details please look at the photos. :)
Unpacking:
The blister pack is easy to open, and the content can be inferred simply stow again and tightly closed again. Here, then, no tools (scissors / knife) is necessary as usual in sealed blister packs. Can I find a good solution.
Battery rear light:
On his website Trelock advertises "Easy to Handle" and "tool-free battery replacement". If you read the following text and the photos that I have extra high loaded -lachhaft!
The battery itself is built taillight not well thought out, neither in form nor function really Alltagstauglich. The use of the supplied AAA batteries designed to be several minutes of waiting game. The whole thing is so unspeakably bad in the construction that you have trouble to open the case at all. Below the housing sits a small black rubber knob you should press very firmly inward to unlock the housing can - but unfortunately it works so not right! The resistance is too high. So while you press, press inevitably from the top with the other hand up and turns on the Anschalter button. The Anschaltknopf is in fact quite a long smooth plastic rocker who already triggered by a slight pressure. It can also happen when you jerk open the case that one a little black plastic nipple (on / off switch) and a tiny metal spring to fall towards you, or in the worst case on the floor and they were no longer finds!
My recommendation: open at rest at home at a table. The rubber cover Pull down only by use of a tool or fingernail and now the free-lying plastic nose inward pressing with a matching object like pencil etc. Doing this helps the housing Pull and finally use the AAA batteries. Put them together-simple slide of the housing and it is firmly seated. Fumble Now even the rubber cover back on it and is good.
Luminous efficiency:
The Battery rear light is quite bright and can be seen well from behind, but scatters it very far and is MMN. too imprecise. The manufacturer gives a 220 ° field of view on. The test to cast light on a wall in about 20 cm distance is distracted and does not convince me. Since there is substantially better taillights of other manufacturers. The visible distance of max. 120 meters (l. Manufacturer) may be true in some of full batteries - in the small LEDs I doubt it but. Positives: it can also be seen from the side of good, since the housing side has an open construction.
Holder:
The inferior bracket with "snap-lock" mechanism I have out of the box called "China plastic garbage". The bracket (cable ties) made of soft but unruly plastic (plasticizers substances) is unwieldy and goes after repeated ad-adjust been broken if you're unlucky. The plastic screw (screw maggots) and the poor locking clip for the taillight housings are useless and obviously not one hundred percent fit for taillight. The plastic clip has some play in the taillight housing whereby a total failure in a very short time threatened. Here is either cancel the holder or drop the taillight on uneven terrain. Both unacceptable!
Something you really do not expect from the manufacturer Trelock. The bracket makes the whole lamp already useless for road use, because you want to quickly disconnect the lamp from the holder in everyday life. An alternative mounting is not possible due to the small / delicate design! A replacement of the bracket is possible, but with approximately 5 not particularly favorable replacement material.
Taillight: Summary
------------------------------------
+ Taillight quite bright
+ Illumination sufficient / good
+ Side visible
+ Low power consumption thanks to "E + Eco Power"
- Water-resistance sufficient (housing / plastic rocker has game: here can water / moisture to enter)
- Scatters light very, no spot like photo
- Open the battery compartment very cumbersome (tool required)
- Possible loss of small plastic button (power button) the jerky opening of the housing
- Mount very deficient, shoe / clip has the game engage the rear lamp to the holder
- Thin lightweight and soft material
Preprogrammed to release smoothly, loss -
- Plastic tape the holder too stiff, headless screw (soft plastic) does not hold, thread wears out quickly!
CONCLUSION:
Poor, not advise!