In the fairly large Plastikblisterverpackung which is pretty easy to beat, fortunately, are the LED Strip, wound on a plastic coil, an AC adapter, a power cable, an infrared remote control and an infrared receiver (RGB controller box). The power cable is a standard cable Euro plug to double socket with 120 cm length, which is connected to the power supply. This power supply unit comprising a green light control, delivers to manufacturer's specification 2 amps at 12 volts DC .. From the AC adapter leads a permanently installed cable of about 90 cm length. At the end of the cable is a connector which is connected to the mating connector of the infrared receiver. From the receiver box then a further plug connector leading to a corresponding port on the LED Strip. In other words: You can bridge good 2 meters to the power supply from the wall outlet to the actual Strip. Until the transition of the power cord to Infrarotbox wiring is black, the Infrarotbox and the actual Strip have the color white. The back of the strip is provided with a double-sided, white tape of the prestigious 3M. Of course, the tape is already applied to the Strip and the back is also provided with the adhesive protection, so that the user still has the full adhesive strength available for its adhesive attempt. For me that sticking was also a great success; even around corners, it has not been solved. Who the 5 meter, it must be much, can shorten the strip frequently, all 9 LEDs appear a small scissors icon on the Strip, here may each be shortened. But please remember: Always cut from the opposite side of the connector, otherwise only a short end depends on the plug. Was I watertight from the LED strip in warm white LED Strip 5M very pleased KooPower stripes - SMD3528 300 LED strip light incl 24W power supply -. Warm white - complete set, I am rather disappointed with the colorful stripes. There are here doesn't install genuine RGB LEDs, but only one red, green and blue LEDs, the succession carry out their work in threes. A true color mixing within a diode is thus impossible and can be seen for example that immediately know just is not white, but red, green, blue light up next to each other and more give an idea of white. Also, there are actually no more than 16 colors. Certain Stepped and dimming effects but work perfectly. The infrared remote control does not make me the strongest impression that thin foiling the surface bulges in some places very, also had the operation on more than 3 meters from the infrared receiver very tough. I then still the ideal application for this Strip found: I have several kits of Lampada Romantica (there is also here at Amazon) standard lamp or lighting column built. The parts of this lamp made of a white translucent plastic. I have attached the Strip within the lamp, or simply let your inside. If the strip is not too close to the outer edge of the light, the colors of the single LEDs mingle then too homogeneous color and a warm white is suddenly possible. Varied color effects or single soothing colors make this lamp a real eye catcher. The energy consumption keeps also here in limits. With the FRITZ! DECT 200 I did not quite 20 Watt measured the hour, based on full length of 5 meters.
I thank the company KooPower, you my test copy free of charge stellte.Dies but does not affect the rating.