Unfortunately I have to send back the module the first time. The module could not be recorded with the firmware and I've tried for hours. If not within 5 min the module. can be played right definitely something wrong with the module!
Now, to the intact module:
The instructions can be found on the website Unicam ([...]) and actually very simple.
Procedure:
Download and install 1. Unicam Loader (in my case I have the vi4.01 used for Windows) does not start
2. Download firmware (I have the Troja v 4:17 used)
3. Unicam connecting module / s using the included cable and the plug "long" module in the CI module
NOT attach the short module !!!
4. Connect the USB cable to the PC and wait for the driver installation.
5. Now also connect the small module with the CI module
6. Start Unicam Loader
7. Select Firmware
8. Start the update process
Now switch the switch on the Unicam module 1
Now the firmware should be put in about 1 minute on the module.
After successful completion of the module is ready for use. Then turn on only the card into the CI module, and both in the TV / receiver and the TV / receiver.
On my Samsung TV, the device immediately recognized and the Sky channels was decrypted (V13 map).
I'm very satisfied because I can send my Sky receiver retire now. Even HDD recordings are now possible at any time!
After the trouble with the first module, I am glad to have made an exchange and hardware technically no longer being dependent on Sky.
If one is faithful to the steps the programming of the module is very simple and really easy to make for himself any.