Delivery as always went so far quickly-within 2 days. The mount is a real part-valent No cheap plastic. Probably just therefore not so cheap. The adapter works as described. Only with the information for the mobile sizes have to be careful with this type of support. The phones have so often lost round corners and thereby give it space to chuck them into the holder. My 5Zoll Cynus T5 fits not only because it is anyway 2mm longer than the maximum specification. By round corners of the phone are missing about 2.5cm in length. Even with the other Aufsteckclips it does not work. Of width I had no problems. The support I keep still, because I finally no longer can fit my old 6310i phone preparation in vehicle Seat Altea only with the age-old Nokia. To fix my 5Zoll Cynus T5 so I will once again take the Velcro strip solution. The holder is rotatable about 90 ° to the left or right. When power supply comes with a 20cm long cable. on one side it has a mini-USB connector angled, comes into the holder, on the other hand the microUSB connector for your mobile phone. Wherein the terminal is currently running for your mobile phone, angled would be better here. But there is at the right angle adapter Amazon example of Com-four. The phone preparation in Seat is from 2004. Had this course again not notice about manufacturer etc. pp .. But thanks to the Internet turned out that this preparation, System 8, by the company. Bury is, even if the stated anywhere in the vehicle is. Oh yes: old Nokia 6310i mount out, new Bury Uni-holder in and running. As Max Cell length I would go out to 12.5cm in other words, a Nokia Lumia 520 would fit in. Is supported by the holder only the HFP Bluetooth profile, so music via A2DP profile with this Bluetooth cradle can not.