I am also a novice in terms Arduino. But this set is really varied. I will list the points even as bullet points, is clear: + Much content for little money (everything would be expensive individually) + You have already everything you need to get started (and more) + Everything was good quality + Funduino board is the Arduino to none + Eg. to use enough LEDs and resistors andernweitig + Fundiono.de explains important matters (even without ordering freely accessible) - Not for all parts of the set there (detailed) instructions (not yet on Funduino.de Arduino pages), for example, I only came out that the "Piezo Speaker" magnetic nature is, because I've entered the barely legible serial number of this , Too bad, because then, for example. the knock sensor not build = / - All small parts were loose in the shipping box (LEDs, resistors, cables were each packed together), no padding> on the motion were bent 3 capacitors (could be straightened out easily again) - Without further aids, the display is difficult to connect (since no connectors are only empty holes in the board), a connector series or two would not be wrong here been - The button and the potentiometer have no matching pins for breadboard (are bent to aufzuklemmen the button eg on something.), They just do not fit into one another (it makes therefore difficult to incorporate them in projects) # Instead of a servo motor, I would have liked more than a stepping motor or a normal AC motor, but is a matter of opinion [and what you do not, anyway mostly great;)]