Have for this manufacturer already some films in use (displays of cameras, navigation and mobile phones). Durable and really hard to see - ie no optical interference factor. The film is tailored. This time the wind the film was not quite as simple as an 8-inch display will be already 'stuck' very tidy. On the route from 'top to bottom' affects a non-milimeter accurate beginning of fatal, because then it does not fit neatly in the end. When Tab3 are above 2 tiny recesses (light sensor / front camera) and the bottom of the 'home button'. Warning - very accurate work! Even 1mm foil overhang on the home button would cause the film does not properly rests and at worst could lift slightly at this point. At least it looked visually does not look good - and you look exactly as it guarantees. , , Ensure staub'freie 'environment and really clean hands. Ready put all resources in advance so that you do not unnecessarily run around and kicking up dust. Do not laugh - every little flake under the film looks later Sch ..... from. In the event that the film has to be raised again for correction: Tesa glue right and left on the sheet corners and so then lift. Tip: So I have both hands free for sticking and the device does not need to keep, I have fixed the Tab3 at the bottom with 2 small strip double-sided tape on the table.