OPERATION:
- TRIPLE NOZZLE, gray for wood-stains, black varnish for wood, and white as the walls,
- AIR FLOW, pictograms facilitate understanding of the settings: "wall" or "wood-stain" or "wood-varnish."
- SPEED PAINTING spray is adjusted with a knob on the gun.
- BROADCAST JET (20-25 cm), is selected between the jet "vertical flat" for the sense of horizontal work (moving from left to right, always keeping the gun perpendicular to the wall), or jet "horizontal flat" for the sense of vertical work (floor and ceiling), or "small round" for angles, edges.
PRECAUTIONS:
Previously unpainted surfaces are masking with the utmost care. Provide a wide masking tape 10 cm. or more simply a less precise gesture to paint a nearby object accidentally ...
The power of the convection tends to peel off the masking tape and in a poorly ventilated corridor, it triggered my smoke detectors.
PAINTING:
I use without dilution to repaint the walls and cast iron radiators from my apartment.
With this light gun is easy and it is very fast to apply the paint with a powerful jet. The jet goes in hard corners Access brush. For example on cast iron radiators time saving is considerable, but above all, the walls must be well protected.
After the second layer, the finish is satisfactory, either on walls or difficult places.
Recommended are gloves, goggles and especially an air filter mask over your nose.
CLEANING:
Empty and clean the paint container, remove and clean the nozzle, the immersion tube.
Fill the container with a liter of water (solvent if necessary) and spray and repeat until a clear liquid.
STRIPPER wallpaper:
Peel off the wallpaper is very long and tedious because the sponge does qu'humecter paper. With this gun 5000E PFS one liter of water is sprayed in under 30 seconds on a wall of 6 m² is so soaked that the strips usually take off in one piece. A second spray of water and the underlying layer can be easily removed at the first passage of the spatula. However I have not tried it on vinyl wallpaper.