For tablet and smartphone I have also installed sheets of atFoliX and thus had huge confidence in the protection that should give me these films for Moto360. The attachment of the first film was used without any problems. At first I perceived the film as a perfect fit, but has settled after a few hours at the bottom left dust under the film, although this has been created without bubbles and without slipping from me. After closer inspection of the problem, I only came to the realization that the film seems to be only if absolutely minimal, slightly too large and thus stands above.
Directly I have delivered the second of three films attached that left a similar picture, unfortunately, after a short time .....
And so the third and final film of mine was mounted on the same day. It failed unfortunately when applying:
The actual screen protector is surrounded like in a sandwich for the delivery of each of a protective "shell" / film. First, of course you pull up from those protective layer which covers the adhesive side of the screen overlay. You put the now exposed adhesive film on to the mobile phone, tablet or even here SmartWatch. Then you pull off the second and last film that still covered the actual screen protector from above.
And this is where it hooked, because here the protective shell dissolved together with the actual protector again.
Now regardless of whether the third film now went through operating or design flaws thus the drain:
Conclusion was that I was disappointed to throw away all three films, and now no protection of the display has been achieved ....
Too bad, I was never disappointed in the rule of atFoliX products.